Stump grinding and removal in Beaconsfield

Grinding lowers the visible stump and accessible root flare beneath an agreed level. It does not usually remove every root running through the ground. A lawn repair, planting bed or future paved area may each require a different depth and finish.

The quote records stump width, height and grinding depth. It also states whether named surface roots are included. Full root excavation, engineering advice and underground-service detection are separate. Woodside carries out the agreed stump work but does not provide a land survey.

A front stump beside a gravel drive may provide a direct machine route. A rear stump can be different. Measure the timber gate, the gap past drainpipes and the turn into the lawn. Show steps, soft ground and any surface that needs protection.

Photograph the stump with a tape across its widest point and include nearby paving, glass and fences. Known metal, stone or buried obstacles must be identified. HSE guidance requires an effective exclusion area because the cutting head can throw material outside the immediate stump position.

Grinding leaves wood fragments mixed with soil. Clean-up is included, but the quote states whether this material remains, is spread elsewhere or is removed. The hole and surrounding level should match the recorded finish rather than a decision made after the machine leaves.

New planting, paving or landscaping is only included when listed. Number each stump where there are several. A stump beside the drive and another behind a gate can require different access and surface protection even when their diameters are similar.